AirBag CAN Service Tool / SmartOBD HELP

[Ljmtuning]

CHECK GND Pin in CASE! (must have 0 Om)

Sorted it was wrong pinout

[Ljmtuning]

CAN wires wrong location to my module

[Ljmtuning]

My pinout needed to be the lower bottom 2 pins

[smart-prog]

Supper thanks added to Software!

[Ljmtuning]

please can you help me with actuvation of tc22xx infineon? i paid yesterday but not recieved my certificate.
thankyou

[Adrian1021]

Marca de coches NOMBRE : TOYOTA
MODELO : FORTUNER
NÚMERO DE PARTE : 89170-0KB70
CPU / memoria EEPROM :R5F6172X
they help me to read it with smart OBD because in the images I don't get the corresponding one

[joker01]

I apologize if I have the wrong section ... but I can't open a new discussion ....
I just bought my airbag start pack, I have a problem with the USB dongle with the sw bag can service tool ....
the dongle continues to disconnect and reconnect by itself.
all the boxes in the lower left from green to red in continuation .....
I have already updated the drivers, I am attaching a screen of the devices on my win10 64bit
whit ast no problem...dongle is connect regular
screen dongle hw.png

[smart-prog]

IF you use USB HUB put external power!
Maybe Change USB port in PC.

[joker01]

Thank you for reply.....
no usb hub, dongle direct to usb pc.
i have also seen videos on the internet and I see the same my fault on some ......
changed usb port but same defect...

[Elder]

Hello, can I use Smart OBD for diagnosing the SRS GN15-14B321-GF unit for the Ford Ecosport car.
Will the connection for this block coincide with those blocks that are specified in the program, or is it better to double-check?

[smart-prog]

Must Work...

[Elder]

In my SRS block, pin No. 11 calls with "0" resistance to the block's ground and not as indicated in the picture for Smart OBD.
Connected, read errors.

[Elder]

[smart-prog]

Now i see all ok You read errors...

[Elder]

GN15-14B321-GF