User Profile

[AST_Support]

Take a photo of your connection.

[AST_Support]

ASTPro can read a locked MCU using a SmartProg adapter and the connection described above.

[AST_Support]

Test this file and post the result. Password in PM....

[AST_Support]

Use a common MCU connection....

[AST_Support]

All part numbers are marked (KLine by dump) or (diag only).
You can always check for crash data using bench diagnostics.

[AST_Support]

Write the original data and perform diagnostics. Most likely, the SRS unit is damaged.

[AST_Support]

All the lights on the dashboard are on. This is some kind of malfunction.
There are no crash data on the bench.

[AST_Support]

No problem. Tomorrow will be replanish.

[AST_Support]

Take photos of the SRS unit cover, connector, and PCB from both sides.

[AST_Support]

Use "KEAD-57K30-C R7F701330" in ASTPro.
You need at least 1 token to do this.

[AST_Support]

You tried to connect the SRS unit several times after writing the data, you may have rotated it.
The cleaned file is correct. Write it again and...

[AST_Support]

Try to perform multiaxis calibration.

[AST_Support]

Write this file and post the result. Password in PM....

[AST_Support]

Try this file and post the result....

[AST_Support]

Use part number 407000470AA in ASTPro and these connections....

[AST_Support]

Enter your AST Card SN in your profile.
Change the polarity of the capacitor.

[AST_Support]

Use a common connection for this MCU....

[AST_Support]

Sent PM.

[AST_Support]

ASTPro supports "Clear Crash by OBD" for this part number.

[AST_Support]

Use the "Clear Crash with Dump" feature in ASTPro.
If that doesn't work, try this good file from another car....