Originally posted by smart-prog
View Post
-
Sorted it was wrong pinout -
CAN wires wrong location to my moduleComment
-
My pinout needed to be the lower bottom 2 pinsYou do not have permission to view this gallery.
This gallery has 1 photos.Comment
-
-
please can you help me with actuvation of tc22xx infineon? i paid yesterday but not recieved my certificate.
thankyouComment
-
Marca de coches NOMBRE : TOYOTA
MODELO : FORTUNER
NÚMERO DE PARTE : 89170-0KB70
CPU / memoria EEPROM :R5F6172X
they help me to read it with smart OBD because in the images I don't get the corresponding oneYou do not have permission to view this gallery.
This gallery has 4 photos.Comment
-
I apologize if I have the wrong section ... but I can't open a new discussion ....
I just bought my airbag start pack, I have a problem with the USB dongle with the sw bag can service tool ....
the dongle continues to disconnect and reconnect by itself.
all the boxes in the lower left from green to red in continuation .....
I have already updated the drivers, I am attaching a screen of the devices on my win10 64bit
whit ast no problem...dongle is connect regular
screen dongle hw.png
Comment
-
-
Thank you for reply.....
no usb hub, dongle direct to usb pc.
i have also seen videos on the internet and I see the same my fault on some ......
changed usb port but same defect...Comment
-
Hello, can I use Smart OBD for diagnosing the SRS GN15-14B321-GF unit for the Ford Ecosport car.
Will the connection for this block coincide with those blocks that are specified in the program, or is it better to double-check?Last edited by Elder; 14.11.2019, 16:24.Comment
-
-
In my SRS block, pin No. 11 calls with "0" resistance to the block's ground and not as indicated in the picture for Smart OBD.
Connected, read errors.Comment
-
You do not have permission to view this gallery.
This gallery has 2 photos.Comment
-
-
GN15-14B321-GFComment
-
Is there any solution for this?
I see also a RH850 1331A...Today, 19:54 -
-
-
-
You can try to write this file. Password in PM....Today, 17:00
-
B1650 - occupant detection system malfunction
This is not a crash data....Today, 16:57 -
-
Reply to Kia carens 2019 95910-a4200 crashUse Clear Crash by dump in AirbagCANServiceTool.Today, 16:24
-
Reply to P32246116 u3000Hello friend, thanks for the tip. The error is actually 95640. SolvedToday, 16:22
-
Reply to Kia carens 2019 95910-a4200 crashfriend i read this dump with cpt programmer but i need this file do clear crash and i write mcu with cpt programmerToday, 16:03
-
898146938Y (by dump)
You need to read the MCU and use Clear Crash by dump.Today, 16:00 -
Reply to Kia carens 2019 95910-a4200 crash95910-A4200 (read only)
You need to write this MCU using a cpt programmer to clear crash data errors.Today, 15:57 -
No problem. Thank you very much for the advise....Today, 15:55
-
The Clear Errors does not work on the bench for this part number.Today, 15:54
-
Reply to CANFD adapter activationAfter the firmware writing is complete, the CANFD adapter should start working.Today, 15:53
Comment