Originally posted by Elder
View Post
-
Thanks for Pinout! -
sorry friend.....on my smart obd have 12volt and gnd to the pins 1 and 25.....
from the pinout on the photos of the sw can airbag the 12 volts and gnd are on pins 2 and 26 .......
is defected my hw???Comment
-
I do not understand your question. May you have the details?Originally posted by joker01 View PostComment
-
On my smart obd have 12volt-pin1 and gnd-pin25......
tried with tester ... anyway tonight if I can upload photosComment
-
-
-
-
Ok....thanks.....Originally posted by joker01 View Post
But is normal my smart obd......???Comment
-
-
Hello, I have a problem with removing crash data in AL3414B321FA Ford F-150 driver. Interface connects and reads errors, but erroneously reads EEPROM content as a completely filled zeros. Log in attachment.Comment
-
Please open ECU for check what CPU inside and post here!Originally posted by MJTSerwis View PostComment
-
Hello, it's Infineon SAH-XC2361A-56F80L34 This module also have separate PCB for acceleration measure connected by soldering on flexible wired tape.Originally posted by smart-prog View PostComment
-
i have now BR33-14B321-AF same CPU and same problem... Please wait i make solution!Comment
-
Hello, any updates about AL34-14B321-FA?Comment
-
-
-
-
Reply to Audi Siemens 8K0959655N B2000:49-89Test this file and post the result. Password in PM....Today, 11:40
-
-
What is the error?
You may just need to replace the seat weight sensor.Today, 11:32 -
Reply to 95910-cw500 not workIt has been done and I will try it on the car and let you know....Today, 11:14
-
Reply to 89170-53790Read and post the dataflash file, it may need to be fixed.
Password in PM....Today, 11:07 -
Reply to CANFD adapter activationPCB photosYou do not have permission to view this gallery.
This gallery has 2 photos.Today, 11:05 -
Hi
I have three PV4T-14B321-AB to reset.
First one reset perfectly OK on workbench by diag.
Other two are stopping...Today, 11:04 -
Reply to 95910-cw500 not workFirst connect and clean the MCU, after writing the cleared file to the MCU, unsolder the EEPROM and clear it.Today, 11:03
-
-
The files look fine, try connecting again.
In the future, please run diagnostics before performing any operations.Today, 11:00 -
Sorry For Repost But For Some Reason Old Post Was UNAPPROVED and would not let me edit it.
Hi
I have an Audi Siemens Airbag...Today, 10:57 -
Reply to Fiat tipo 00052195566It is not recommended to write pflash on this MCU.
Here is why it is forbidden on cpt.Today, 10:52 -
The accident data has changed status to history.
It will be cleared on the car.Today, 10:48
Comment