Hello, read data is not working. It loads to 100% and does nothing. Can you help?
-
-
Take a picture of your connection for better help -
Could it be a bad connection if the processor is recognized?Comment
-
You need to make a Y connection for the p8 wire and it needs to be around 5cm long or below for the bypass to workComment
-
You were right. Thank you very much.Comment
-
I did flash + eeprom, but dtc crash data is active. I have hyundai diagnostic obd online bypass, but I can't delete errors.
I read a second time 95256 for verification, the information is what carprotool clear crash data did.
Should I check flash data, or is there any other trick that throws crash data dtc?Comment
-
After bypassing the MCU did you clear crash by dump and then click write data?
Then you need to clear eeprom straight away, if you powered the module before clearing the eeprom, the crash data would be written back.Comment
-
Yes, i saved flash and then write it. Then I did the eeprom. After flash + eeprom I have a crash data dtc. 95256 as I mentioned I checked and found the ast cleared file. It seems that I will need to read the flash again and check the file...Comment
-
Check all soldering points, clean the board, and check the EEPROM soldering.
Take a photo of the EEPROM.
Before installing the SRS unit on a car, you should first perform diagnostics on a bench.Comment
-
I did a couple of these modules and all went ok no problems, try it againComment
-
It seems that the coding is gone. I am attaching a photo before starting work with existing dtcs. After the work and dtcs are practically gone, only to replace the srs ecu (strange, because the airbag is not connected to the table).
Is there anyone who can check the files?Comment
-
Take good quality photos of both sides of the board.
Read the MCU data again.Comment
-
-
Files cleaned correctly.
You can write the original files for testing.Comment
-
Original flash data and eeprom. Is it possible that the flash read was bad? I am attaching the flashComment
-
From the log files on the server.Today, 14:05
-
How u know I restored everythingToday, 14:00 -
Reply to Tesla model 3 2025 1512876-00-e2 tokens will be added.
But it's all your fault, you didn't do the initial diagnostics.Today, 13:59 -
You restored everything yourself. Great job.Today, 13:55
-
With good soldering skills, everything works without problems.Today, 13:53
-
Reply to 89170-16240 wireEnter your AST Card SN in your profile.
Take a photo of a new connection.Today, 13:50 -
-
-
Reply to mopar 9869435280 citroen c3 2024If you press the DoIt button, there will be a connection to the MCU.Today, 13:48
-
Reply to Smart obd not detected.You can buy a new FTDI and replace it.
The FTDI from another tool may have a different configuration.Today, 13:46 -
Reply to mopar 9869435280 citroen c3 2024In ast pro i can find only bench connection to diag :/...Today, 13:46
-
-
Try this file, password in PM....Today, 13:43
-
-
)
Comment