ABT2015
Senior Member
Last Activity: Today, 17:20
Joined: 27.01.2016
-
You're missing a short to GND, check pinout again -
check againYou do not have permission to view this gallery.
This gallery has 1 photos.Leave a comment:
-
I did a couple of these modules and all went ok no problems, try it againLeave a comment:
-
After bypassing the MCU did you clear crash by dump and then click write data?
Then you need to clear eeprom straight away, if you powered...Leave a comment:
-
You need to make a Y connection for the p8 wire and it needs to be around 5cm long or below for the bypass to workLeave a comment:
-
Take a picture of your connection for better helpLeave a comment:
No activity results to display
Leave a comment: