Can't clear crash / KEAD 57K30 C / Mazda

[techautoltd]

On another note, can these SRS modules be reset to factory so that a full Module install can be performed to reload a fresh configuration?
Is it only the VIN that needs to be cleared to have a virgin module?

Sorry for so many questions, but I would like to know if there is an alternative process to clearing the crash only.

Your thoughts would be greatly appreciated.

[AST_Support]

It may be a short circuit in the SRS unit.
You need to clean the board, check all the soldering points, check for short circuits on the MCU or Bosch drivers.

[Autotech0522]

Good morning, I'm working on the following vehicle: Mazda CX-90 Module: KDNB 57K30 Module CPT: K0B1-57K30 It was reprogrammed according to the diagram, and the process was followed, but the error code B1193-00, "COMPLETE AND LOCKED COLLISION MEMORY," remains. The status is "past," but it cannot be cleared. Can you help me? I verified that there were no hardware errors, the capacitors were properly soldered, and everything seemed correct. The entire process was performed according to the diagram, including cleaning the EEPROM. Could you please help me figure out how to clear this error? It's the only one that appears on the scanner.

[AST_Support]

If you clear the EEPROM and then turn on the SRS unit, the crash data will be restored.
You need to clear the MCU and EEPROM, and only then perform diagnostics on the bench.
Try to clear the EEPROM again.