Pinout Cpt

[Tahir]

Hello! Adapter ISP_v1.0 S/N: C99B292C23D5D684 Found interface s/n : 903C34F9DAC69839

I recently bought ISP ADAPTER. I changed all the resistors in the CPT programmer according to your scheme. After that, I had problems. Processors in airbug modules do not read all data. DFLASH is not read the first time. And PFLASHs are not readable at all. Sometimes DFLASH is not recorded either. After a while, reading or writing stops. Watch the video Whatsapp

[Jacek147]

Send me:
- photo of bouth sides CPT pcb after resistors chage
- photo of configuration ISP (jumper)
what power supply tou use?
what CPU you try to read + photo of soldered wires

[Tahir]

Hello! Data flash read without any problems. Flash 0 and flash 1 do not read 100% .Log and photo attached. Sometimes DATA FLASH doesn't read either.

B.R. Tahir

[Tahir]

It heats up very much LM317

[Jacek147]

Hello!
Few additional questions:
- Is LM317 heats up when You connect only power supply (without USB)?
- It is heats same when ISP is connected (same only power supply and without USB)
- It is heats same when connected ISP and SRS unit (same only power supply and without USB)
- Did you check with this config? Link