13589689-Autolive_2014-Meriva_XC2361A-56 no pinouts and problem to read content!

[asid12]

Hello!
I have 13589689-Autolive_2014-Meriva_XC2361A-56 . This module working on car and on table and have internal hardware error! I do not find pin-out to connect w/o full disassemble and try to do my self. I have no success to read in any condition this module!

May be someone have any idea?

Pictures of board in attachment!


BR,
Andris

[smart-prog]

Check This LINK AGAIN : Index of /download/Pinouts/CarProTool Programmer/CPT JTAG XC2xxx

[asid12]

I did like in pictures for CPT_GM2012_jtag.JPG ,
but still no result!

Finally I lift up pins 60+62 and put to +5, then read by TX/RX with Carprog and SMOK(boot Mode).

JTAG still do not work with my unit! I have this unit for tests (internal hardware error inside) and I can do tests with fully disassembled board. But Donor ecu I do not like disassemble or make hole for pins lift up and so!

Do you have another idea then show me files?

BR,
Andris.