Mazda Crash clear problem, KEAD-57K30 C

[ddsym85]

Hello.
I cleared file using your service but after clearing the crash, it only shows 3 errors on scan tool while all airbags and components are disconnected. I am testing it on bench. I removed 8 pin external eeprom and erased it since your software says dont forget to clear it but there is no button or option to clear 8 pin eeprom. What should i do now?

Connect MCU... ok
Get device type... RH850 P1x-C
RH850-P1 counters - 10
Set Oscillator Frequency... 16MHz
Set Baudrate... ok
Read MCU lock status... unlocked
Read password security status... not secured
Read MCU type... R7F701330A
CodeFlashSize = 00200000
DataFlashSize = 00018000
UserBootSize = 00000000
Read ICUS Status On... failed
Read Option Bytes... failed
Get Protection Byte... ok
Read disabled
Write disabled
Erase enabled
Start Sending Loader... !!! LOCKED !!!
Bypassing MCU lock security...
Bypassed. ok
Sending Main Loader...ok
Get Seed... ok
Enter Password... ok
Creating backup "Mazda KEAD-57K30-C R7F701330 OPT 01.05.2025 17.33.53.bin" ok
Set Read Mode... ok
Read Option Bytes... ok
Set Read Mode... ok
Creating backup "Mazda KEAD-57K30-C R7F701330 CodeFlash 01.05.2025 17.33.58.bin" ok
Read CodeFlash... ok
Creating backup "Mazda KEAD-57K30-C R7F701330 DataBoot 01.05.2025 17.44.41.bin" ok
Read DataBoot... ok
Creating backup "Mazda KEAD-57K30-C R7F701330 DataFlash 01.05.2025 17.44.55.bin" ok
Read DataFlash... ok


DC power supply voltage +15.11V
Turn on 12V on the adapter... ok
Connect... ok
Read Part Number... KEAD-57K30-
Read SW Number... KEAD-57KK2-C
Read Calibration Number... failed
Read HW Number... KEAD-57KK1-
Read Serial Number... 000000008NMAC2FB
Read Original VIN... JM3KFBCM6P0151122
Read Errors...
B00A0:87-8B - OCCUPANT CLASSIFICATION SYSTEM (Missing messages)
U0100:00-8B - LOST COMMUNICATION WITH ECM/PCM
U0155:00-8B - LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IC) CONTROL MODULE
--------------------------------------------------------
Clearing crash by dump... ok
Clearing internal errors by dump... not found. Don't forget to clear the external EEPROM.

[ddsym85]

files

[ddsym85]

Serial number: 05711290

steps i did: I read the file , clicked on clear crash, then write back, disconnected everything. Wait 5 minutes, i didn’t connect any power suply. Then removed eeprom. Erased it completely (all FF), installed it back and read error. On bench it only shows 3 errors

[smart-prog]

For Extarnal EEPROM Use "RH850 External 95xxx EEPROM" algo!
And You must fixed CAR! SRS System Work Ok! You bmust fixet this error!

[ddsym85]

Hello, i used RH850 external crash clear by smart obd, i had back up from eeprom and tried to used that. Again all is same. Why do i need to try on car? Is there any difference between errors registration on bench test and car test?

[smart-prog]

You make diagnostic on table and have only this error?

[AST_Support]

The SRS ECU is damaged and you did not perform the first diagnosis before clearing the crash data.