Did you connect 12V from the SmartProg adapter?
-
-
!!! 12V OVERLOAD !!!
Connect MCU... ok
Get device type... failedComment
-
Wait !!!Comment
-
Take photos of all the wire connections, something is not connected properly.Comment
-
here connect
Mazda Bosch KEAD-57K30-C R7F701330
--------------------------------------------------------
Connect MCU... failedComment
-
Unsolder all P8 and GND2 wires and clean the board.
Take a photo of the other wires.Comment
-
send solder try againComment
-
Show the soldering on the other side and the 12V connection.Comment
-
-
side upYou do not have permission to view this gallery.
This gallery has 1 photos.Comment
-
Also unsolder this P8 wire and clean this area.
And try to read data.Comment
-
hello,how did you solve this problem?Comment
-
Take a photo of your connection.Comment
-
Reply to help Clear for this dumpHi. Thank you so much for uploading the cleared file.Do you think i can get the password to the file please...Today, 01:02 -
-
-
I found my mistake. Power should be from smart obd. Not external....Yesterday, 20:12
-
why no one try help me?Yesterday, 20:12
-
Hi sir
please can you help me for KEAD-57K30 C
i lost 2 tokens i tried 2 times for clear crash but crash coming again!!
please how...You do not have permission to view this gallery.
This gallery has 1 photos.Yesterday, 16:56 -
Hello again mates, did you have the chance to check the file? thanks a lot in advance,....Yesterday, 15:19
-
-
-
Start Sending Loader... !!! LOCKED !!!
Bypassing MCU lock security... ,:,:failedYesterday, 15:10 -
Reading by smartprog:
Connect MCU... ok
Get device type... RH850 standart
Set Oscillator Frequency... 16MHz
Set Baudrate......Yesterday, 14:30 -
-
-
Hello mates,
I am trying to read a 95910-N7070 KIA HYUNDAI unit, but i get the message i attach on pictures, am I using the correct adapter?...You do not have permission to view this gallery.
This gallery has 3 photos.Yesterday, 13:16 -
Hi, I should reset this Subaru airbag control unit, I read it with Smart Pro, then I should write the virgin file with a UART connection but I can't,...Yesterday, 13:14
Comment