Zeekr 001 2024

[salim124]

Zeeker 001
2024
BOSCH 6608089881
CPU :R7F701330
HI I have this car a cupules days ago I bought tokens to clear the crash but i have been trying to connect by the bench several days but did't work
I saw that there are two images one by bench and the second one need to remove some parts from the computer and solder it again . now i want to know what is the difference between the two ways and what to do in the next step

[AST_Support]

Enter your AST Card SN in your profile.
This connection is for "Clear Crash by OBD" only. "Connect and Read Errors" will not work.

[salim124]

Sorry I didn't understand how I am supposed to clear the crash without reading the computer

[salim124]

I already tried to clear the crash by the obd but I'm getting a fault

[AST_Support]

Enter your AST Card SN in your profile.
And what is the error?

[salim124]

I shared my SN you can see it my profile
I sent you the logs you can see everything when I try to clear the crash it gave me failed

[AST_Support]

This SRS unit cannot be cleared by OBD.
You need to unsolder all the capacitors marked with red squares and make the connection as shown in the picture.

[salim124]

HI the image its not so clear. do I need to make a connection between all removed capacitors with blak line and the P8 or only with the capacitor on the right one of the image

[AST_Support]

This should work with just one P8 wire connected.
If bypass doesn't work, try connecting all wires to P8.

[salim124]

what about the one at the top where you wrote " solder capacitor 400-600nf " do I need to remove it and put something else or only remove it and then to try to connect

[AST_Support]

You need to replace this capacitor with a 400-600 nF.