Hello! Can you tell me when it will be possible to reset the crash of a Toyota ecu with a CYT2B93BAC processor?
-
but for "on car" SRS units, it can write crash data back when doing those on bench ?...Today, 16:33 -
Reply to 98221FN12B fail 3rd in a rowit reads OK when checking DTC and connection by CAN busToday, 16:31
-
Reply to P56054302ab 95256I check DTC with Launch scan tool and with OBD star because they read DTC codes in 3 seconds.
But AST Pro takes around 15 seconds to connect to...Today, 16:29 -
-
-
-
Reply to help Clear for this dumpfor some reason, when i clear it, it still shows it has a crash data on the module. You mind sharing a cleared file, please?Today, 16:12
-
Reply to Carprog CANFD Adapter not workingPlease check picture, It failed the test on this one. what can i do? thanks.You do not have permission to view this gallery.
This gallery has 1 photos.Today, 14:32 -
Reply to Hyundai 95910-G4000B1620:00-89 - !!! SRSCM INTERNAL FAILURE !!! appeared after i cleared crash by dump. I saw on other posts that you have given an good file for cleari...Today, 14:30
-
Reply to 98221FN12B fail 3rd in a rowDisconnect P8 and GND2, solder 2 capacitors back and try to Read Data.Today, 14:24
-
-
There are other buttons, not only "Clear Crash by OBD".
You should press "Connect and Read...Today, 14:21 -
-
-
Reply to Carprog CANFD Adapter not workingSelect, make a connection and run "SmartOBD Test".
Then do the same with "CANFD Test".Today, 14:15