SmartProg make P8 wire shorter

[DAN007]

I bought SmartProg a month ago. Yesterday I got module for Subaru 2023 #98221 FN22A (R7F701686). I connect by OBD and read codes. I tried to read MCU, shows me message "make P8 wire shorter". I shorter wire to 3 cm but it still showed the same message. What solution with this problem

[AST_Support]

To test P8 in the SmartProg adapter, go to the main model selection window in AirbagCANServiceTool and measure the resistance between P8 and GND2 with a multimeter, it should be 0.
Next, make a good GND2 connection. A better way is to solder a good wire from GND2 to the SRS or connect GND to SRS ECU connector as shown on the picture.
Next, try to make a Y type P8 connection cable.

[DAN007]

Resistance between P8 and GND 14,26 kOm. On picture, I not sure this is transistor or something else, but resistance between two marked pins is 85 Om. Is this normal?

[AST_Support]

Connected SmartProg to SmartOBD and run AirbagCANServiceTool?

[DAN007]

When I connect and run AirbagCANServiceTool, Voltage between P8 and GND is 1.25 V, it's impossible measure resistance

[AST_Support]

1.25V appears when you press Read EEPROM button.
Go to the main model selection window in AirbagCANServiceTool and measure the resistance between P8 and GND2.

[DAN007]

When I press Read it decreases from 1.25v to 0.68v. Resistance is 20 MOm if I change the polarity it shows zero. But it not resistance.

[AST_Support]

Ok, try to disconnect the USB from SmartOBD and measuring the resistance between P8 and GND immediately after connecting. You can even close AirbagCANSrviceTool.
Take a picture of the SmartOBD pcb.