Doesnt read via OBD or on bench,it updates ok and all the leds light up as they should.It attempts to read and it shows 12v supply voltage ok and attempts to read module part number but gives message-NO answer from Airbag,check Airbag connection and power supply.
Announcement
Collapse
No announcement yet.
Smart OBD stopped working
Collapse
We are open for you
Collapse
Mon - Fri
10 AM - 6 PM
Current time is:
Latest Activity
Collapse
-
by ivomarchevI wrote this file , and that is report from diagnostic...
-
Channel: AirBag Service Tool by DUMP
Today, 18:43 -
-
by ivomarchevTHANKS , do you have clean file for...
-
Channel: AirBag Service Tool by DUMP
Today, 18:30 -
-
by Turop28Good afternoon. Please tell me what manipulations are needed after replacing the processor. I purchased the R7F7016863 processor for the Subaru 98221FN12A...Today, 15:35
-
by AST_SupportThat's good, the MCU is still alive, try to connect to CPT and try to read again.
-
Channel: Infineon TriCore TC2XXX Programmer
Today, 14:50 -
-
Reply to help for clear crashby kaseem757Send photo of the ecu... I will clear it for you...Today, 14:44
-
by sszaki1971You do not have permission to view this gallery.
This gallery has 1 photos.-
Channel: Infineon TriCore TC2XXX Programmer
Today, 14:41 -
-
by AST_SupportConnect and read the errors with the AirbagCANServiceTool to check if the SRS ECU is working.
Then check the connection and try to read the MCU...-
Channel: Infineon TriCore TC2XXX Programmer
Today, 14:07 -
Comment