I need the pinout to read it please thanks there is not pin out in here not more
Announcement
Collapse
New topic template
Every new topic with question for pinout MUST contain those paragraphs
CAR BRAND NAME:
MODEL:
YEAR:
PART NUMBER:
CPU:
+ at least 4 pictures: of case with sticker, both sides of PCB and zoomed CPU (do NOT resize pictures!)
Subject should looks like "CAR BRAND, MODEL, YEAR, PART NUMBER, CPU" (for example: "Toyota Yaris 2015 89170-0D740 H8SX R5F61725")
CAR BRAND NAME:
MODEL:
YEAR:
PART NUMBER:
CPU:
+ at least 4 pictures: of case with sticker, both sides of PCB and zoomed CPU (do NOT resize pictures!)
Subject should looks like "CAR BRAND, MODEL, YEAR, PART NUMBER, CPU" (for example: "Toyota Yaris 2015 89170-0D740 H8SX R5F61725")
See more
See less
2010 ford mustang mac7242 pinout help ar33-14b321-ca
Collapse
X
We are open for you
Collapse
Mon - Fri
10 AM - 6 PM
Current time is:
Latest Activity
Collapse
-
by SimanHi
Could you please clear this file, managed to clear Frontal collision - 1 but still Crash Event Status - 1 remains.
Please see attached...-
Channel: Infineon TriCore TC2XXX Programmer
Today, 14:05 -
-
by Turop28All connectors are connected 100%. Tested many times.
And the error sounds like the sensors are not recognized. They are not disconnected...Today, 14:03 -
Reply to can we read this chipby sahibjpI have good photo but form not support big size picture...Today, 13:57
-
Reply to can we read this chipby AST_SupportNo.
Make a good photo of this component....Today, 13:55 -
by AST_SupportAll errors are active. Check the connections of all 3 connectors on the SRS ECU, 1 may be not fully connected.Today, 13:53
-
Reply to can we read this chipby sahibjpONLY THREE FREQ HAVE IN PROGRAM OSCILLATOR
AND I DO NOT KNOW WHAT IS THE nearest frequency...Today, 13:47 -
Reply to can we read this chipby AST_SupportTake a picture of the oscillator near the MCU.Today, 13:35
-
by AST_SupportI don't see active these errors or passive. Run diagnostics with SmartOBD and post all error codes here.Today, 13:26
-
by Turop28So the problem is that before I changed the processor, there were errors only in the airbag squibs, there were no errors in communication or sensors....Today, 13:22
-
Reply to can we read this chipby AST_SupportConfiguration -> Set frequency generator
You need to select the oscillator frequency near the MCU.Today, 13:12
Comment