BK3T-14B321-AD xc2361 dtc delete?

[Ljmtuning]

Good evening,

Ive got an issue with the above module,original unit water damaged,replacement module ive programmed with dealer tool but I have B00D5 and B00DF passenger airbag switch not connected,the van doesnt have an airbag switch and i can see in live data the disable switch isnt configured either,very strange issue but im wondering can we delete the fault code from dump?

Pictures added to post of the faults

[AST_Support]

The part number or software version of the donor SRS unit may not match.

[Ljmtuning]

The part number or software version of the donor SRS unit may not match.

Hi,

The part numbers match and the pcb part number match and pcb looks the same exactly,as I say i programmed the replacement module with ford dealer tool which went ok but for some reason its looking for a passenger airbag cutoff switch,although no code for a passenger airbag,im now wondering if I can flash a file from another airbag control unit that doesnt have the passneger cut-off switch to see if my error clears.

Thankyou

[AST_Support]

Try to write this file. Password in PM.

[Ljmtuning]

Thankyou at the moment im struggling to read the good module,I get login exit with status 0

Ive checked connection only 1 wire im unsure about as on the can adaptor its showing cpt6 as nSRST is this reset (yellow) thanks

[Ljmtuning]

Try to write this file. Password in PM.

Also sorry ive put wrong chip description mine is XC2366A

[Ljmtuning]

Try to write this file. Password in PM.

Could you send a file thats for xc2336A and could I write that by can at all? As the bench connection doesnt seem to be working

[AST_Support]

The file is the same for XC2336A and XC2361A.
You can read/write by OBD using ASTPro.

[Ljmtuning]

The file is the same for XC2336A and XC2361A.
You can read/write by OBD using ASTPro.

Hi ive wrote the file supplied but now I have no connection on bench

[AST_Support]

Write the original files and run on-bench diagnostics.

[Ljmtuning]

Write the original files and run on-bench diagnostics.

After leaving module a few minutes it came back online,on bench the passneger switch deactivation fault code wasn't there but when plugged into van it cane back which is very odd,im tempted to swap the mcu over as I cant seem to resd the new or old module with cpt just says target not found