Hi, I try to read the control unit in question in Jtag mode by connecting the 8 wires as per the manual but it does not read. It gives the error of which I attach photos. Could someone help me? Thanks
-
You do not have permission to view this gallery.
This gallery has 1 photos. -
Check your connection and try again. -
I unplugged and reconnected twice, no luck.
Are the jumper settings on the board correct? I attach photosYou do not have permission to view this gallery.
This gallery has 1 photos.Comment
-
Use our software for clear you original file!...Today, 14:44
-
-
Reply to 2019 w253 BMS resetPlease test this file!
Password in PM.
Post result here!
P.S.no result no help...Today, 14:37 -
-
-
Thank you for your support. I think I will have to order a new one, as it never worked since I first received it. It might have been faulty from the ...Today, 14:32
-
All data change in Server ... You must make update units!...Today, 14:15
-
Reply to Volvo v40 2013 T31406254I CANT FIND HOW TO ADD PASWORD ,and cant open or save it...Today, 14:04
-
I've tried a few different SRS now and always the same message 'connect...failed', is there anyway to test the interface? Also the red LED on the smart...Today, 13:57
-
Reply to egea-52017547 crash data clearWhy didn't you connect it on the bench after writing the EEPROM?
Post here that cleared file.Today, 11:18 -
Reply to egea-52017547 crash data clearI did it and installed it, only this error remainedToday, 11:14
-
If you ordered SmartOBD with your Card and Box SN, it will work out of the box.Today, 11:08
-
Reply to Volvo v40 2013 T31406254Try to write this good file from another car. Password in PM....Today, 11:06
-
Reply to egea-52017547 crash data clearTry "Clear Crash by dump" in AirbagCANServiceTool and write the file back to EEPROM.Today, 11:03
-
Check that the SRS ECU is 100% working or try connect another KLine unit.
Try to change the chip L9637D on SmartOBD.
If that does not help,...Today, 10:58
Comment