Dodge Ram Promaster crash data

[Aymenfadhil89]

Car Brand Nameodge Ram
Model : Promaster
Part Number:68563499Ab
CPU/EEPROM: R7F701064
hello everyone , i have this module and i tried to clear the crash but it keeps saying failed and i tried to read the eeprom using smartprog and the message was either connect MCU.... failed or connect MCU..... ok but get device type .....failed
what should i do ?
thanks alot

[AST_Support]

Enter your AST Card SN in your profile.
Take a photo of your connection to the MCU.

[Aymenfadhil89]

i added my AST Card SN
so the MCU is locked and i need to use the wiring method on the MCU ?

[Aymenfadhil89]

Which one is the MCU that i need to read ?

[AST_Support]

I don't know for 100%. You can try the connection without P8 and desoldered capacitors.

[AST_Support]

This is your connecting pinout.

[Aymenfadhil89]

i did follow the connection pinout but still cant connect to MCU
assuming that my connections ok what should i do should i clear by obd or read the eeprom and clear by dump throgh smartptog?

[AST_Support]

Disconnect everything except the Smart Prog RH850 wires as shown in the picture above.
The P8 wire should be less than 10 cm.

[Aymenfadhil89]

hello sir, thanks for the files. i did follow the instructions and connect the wires as shown in the picture but still have the same problem. i want to know if I'm doing something wrong and what are the common mistakes with this type of wiring

[AST_Support]

Disconnect and unsolder all the wires and clean the board. Restore 2 capacitors that you unsoldered. Connect only the wires for RH850 without P8 and press read EEPROM.