2018 Honda Accord
77960-TVA-A460-M4
MCU: SPC56AP54
need pinout how to connect to mcu by points on the pcb.
77960-TVA-A460-M4
MCU: SPC56AP54
need pinout how to connect to mcu by points on the pcb.
-
You do not have permission to view this gallery.
This gallery has 4 photos. -
What voltage does it require ?
And do any pins need to be lifted ?
I tried according to that diagram , reads ok but when programming and than verifying the read again , the verified read looks completely different.Last edited by TR808; 19.06.2018, 16:10.Comment
-
-
Tried erase?Comment
-
Hello again mates, did you have the chance to check the file? thanks a lot in advance,....Today, 15:19 -
-
-
Start Sending Loader... !!! LOCKED !!!
Bypassing MCU lock security... ,:,:failedToday, 15:10 -
Reading by smartprog:
Connect MCU... ok
Get device type... RH850 standart
Set Oscillator Frequency... 16MHz
Set Baudrate......Today, 14:30 -
-
-
Hello mates,
I am trying to read a 95910-N7070 KIA HYUNDAI unit, but i get the message i attach on pictures, am I using the correct adapter?...You do not have permission to view this gallery.
This gallery has 3 photos.Today, 13:16 -
Hi, I should reset this Subaru airbag control unit, I read it with Smart Pro, then I should write the virgin file with a UART connection but I can't,...Today, 13:14
-
Reply to Airbag - toyota airbag - 89170-0dg20Hi,
I have the same problem. I had 3 different 89170-0dg20 the last 9 months and none was done. My P8/GND are about 8cm long. A also had...Today, 11:59 -
Hello.
R7F701064 + 95256 eep.
Smart OBD write:
Enter Password... ok
Clear Crash1... failed
Clear Crash2... ok
...Today, 11:24 -
We are working on such a SRS module LT4T-14B321, MCU type is R7F701A033 with error U-3000. We are trying to read it with the CPT programmer but we are...Today, 11:17
-
Reply to mazda mx5 93c86 eepromlevan can you send me the clear flie i need big thanks!!!...Yesterday, 22:29
-
same happenes here.
anyone know what to do ?
I do all SRS ECUs on bench outside of car...Yesterday, 21:28 -
Hello.
Do you have solution this time, for that proc?Yesterday, 20:31
Comment