Nissan 98820-6cb1b

[Dd1]

Hello everyone, i have a nissan altima crash data, i did the connection according to the pinout diagram, it wont read, error i get is for wrong mcu. i have checked and it is the right mcu. including the pictures. it is INFINEON TC22XXX16

[CPT]

Hello.

Connection correct - MCU details detected.
What MCU on Your module ?
What MCU type and number selected ?

Can You create debug log please and upload here.


HOW TO CREATE DEBUG LOG

1. Click on “interface” button in cpt exe.
2. Select “Debug On” button.
3. Make operation on cpt exe ( read or write ) and wait for finish.
4. Again click "interface" and unselect "Debug On"
5. Cpt exe give You information about “debug log” location. Place send debug log file to us.

Regards

[Dd1]

Hello.

Connection correct - MCU details detected.
What MCU on Your module ?
What MCU type and number selected ?

Can You create debug log please and upload here.


HOW TO CREATE DEBUG LOG

1. Click on “interface” button in cpt exe.
2. Select “Debug On” button.
3. Make operation on cpt exe ( read or write ) and wait for finish.
4. Again click "interface" and unselect "Debug On"
5. Cpt exe give You information about “debug log” location. Place send debug log file to us.

Regards

HI, since i was not notified with an email i should send, so i sent it to the shop@diagcar.eu please kindly look at it and have a solution for me, since my job and client are waiting. much appreciated

[Dd1]

Anything??????

[alexsav2102@gmail.com]

Hi, did you get to read file from module? If yes, can you please upload file with crush or cleared. I need that, because I have a new blank module from dealer.

[smart-prog]

What problem blank module from dealer.?
You read data from this ECU?

[alexsav2102@gmail.com]

When installing new module on Nissan it is empty and needs to be programmed through dealer program where need to pay for that.

[smart-prog]

Check you other topic! Please stop make copy them...